Ultra SlimPak II – The best Signal Conditioner Family Ever Produced

ultraslimpak2

Benefits

Lower Power Requirements with “Smart Power” Control The Best Input/Output Accuracy and Stability Available Input Accuracy of 0.015% Output Accuracy of 0.05% Stability of 100ppm Field Configurable Integral Diagnostic Capability Versatile Alarm Capabilities provide E-mail Notification when Problems Occur

Features: “Smart Power” to reduce power consumption and temperature rise. Configured using DIP switches pushbutton calibration (like the Action I/Q series)

Limit Alarms
WV108 DC Input, Field Configurable Limit Alarm
WV118 RTD Input, Field Configurable Limit Alarm
WV128 Thermocouple Input, Field Configurable Limit Alarm
WV168 AC Input, Field Configurable Limit Alarm

 

Signal Conditioners
WV408 DC Input, Isolating, Field Configurable Signal Conditioner (NEW FEATURES!)
WV418 RTD Input, Isolating, Field Config. Signal Conditioner
WV428 Thermocouple Input, Isolating, Field Configurable Signal Conditioner
(NEW FEATURES!)
WV438 Potentiometer Input, Isolating, Field Config. Signal Conditioner
WV448 Bridge Input, Isolating, Field Config. Signal Conditioner
WV468 AC Input, Isolating, Field Config. Signal Conditioner
WV478 Frequency Input, Isolating, Field Configurable Signal Conditioner

 

Optional Interface
WVC16 I/O Communications Interface Module
DDEServer DDEServer Software Distribution for WVC16 I/O Communications Interface

 

Power Supply
WV905 I/O DIN Rail Mount Power Supply, 24VDC @ 0.5A

 

Smart Power

Smart Power adjusts the output voltage and current, depending on the power output required to drive the current load. A low impedance current loop will subsequently use less power than a high impedance current loop. Previous designs provide only a single supply at the highest voltage required to drive the highest impedance load. Smart Power can save as much as 1/2 Watt per unit and reduce the operating temperature as well.

Enhanced Diagnostic LEDs.  Blinking LEDs communicate the following information:

GREEN:

2Hz when the input is under range 8Hz when the input is over range

RED:

2Hz when the output is under range 8Hz when the output is over range

Configuration

In addition to the DIP switches and pushbutton, it is possible to remotely configure each module, using an Ethernet connection to the WVC16 and a remote PC-based web browser.

Integral Diagnostics

Besides the four diagnostic LED’s, further diagnostic information can be obtained using a computer. All Ultra SlimPak II units can provide HI/LO and overtemperature soft alarms when used with a WVC16 communications interface.